Do I need anything else before I begin?

302 Views 7 Replies 6 Participants Last post by Brandon - TX, Oct 25, 2003

Brandon - TX

Discussion Starter · Oct 24, 2003

I have Progress springs and Eibach dampers sitting in my garage. Is there anything else I need to have to do the install correctly besides whatever I remove from stock form?

Save

1 - 8 of 8 Posts

jptech2004

· #2 · Oct 24, 2003

basic hand tools and a coil spring compressor.

Save

IDversusEGO

· #3 · Oct 24, 2003

and beer. plenty of cold beer. If it's your first time doing the swap, an extra set of hands would help too.

Save

Silfox

· #4 · Oct 24, 2003

A 15mm socket is gold

See less See more

Save

Hitokiri

· #5 · Oct 24, 2003

Don't forget to budget some chamber kits and an alignment (mispell?) after you put on your kit. Your chamber shouldn't be that bad but I wouldn't be suprised if your alignment was off.

I know this is usually AFTER you put on your kit but just telling you.

See less See more

Save

jRock

· #6 · Oct 24, 2003

Say man are you near DFW at all? I have a kit to put on too and I'd be glad to help you if you help me

. This Sunday maine.

See less See more

Save

jptech2004

· #7 · Oct 25, 2003

Don't forget to budget some chamber kits and an alignment (mispell?) after you put on your kit. Your chamber shouldn't be that bad but I wouldn't be suprised if your alignment was off.

I know this is usually AFTER you put on your kit but just telling you.

the word is CAMBER

See less See more

Save

Brandon - TX

Discussion Starter · #8 · Oct 25, 2003

Im getting it done at a shop.

I am not near DFW, altho its funny u ask. I lived there(Arlington) for 17yrs before I moved up here to IL.

thx for thr help guys.

Save

1 - 8 of 8 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month