Ford Focus Forum banner
1 - 10 of 10 Posts

· Registered
Joined
·
6 Posts
Discussion Starter · #1 · (Edited)
wrapped my focus around a pole a couple of years back. Still have the remains of my former car in my garage. lately my family has been in need of another dependable car so i've been shopping around and found a 2003 focus zx3 in great shape except for the fact that it's transmission is busted. So my question is, can my 02 tranny fit the 03 zx3? i need to know for sure they're compatible so lmk. I want my focus back
 

· Orange cones scare me
Joined
·
3,458 Posts
Well it depends on the motor if its a zetec to zetec then yes it will work zetec to duratec will not work same as zetec to spi or svt
 

· Orange cones scare me
Joined
·
3,458 Posts
Here ill give you a reasons why this is the zetec manual is a 5 speed mtx75 the duratec manual is also a 5 speed mtx 75 but has a different bellhousing that will not match to a zetec engine spi I have no clue what the manual trans name is ik though it is not a mtx 75 as for the svt it is a 6speed and is called the getrag no other engine but a svt will work with it on a side note the duratec and zetec mtx75s can be interchanged if you change their bellhousing apropriate for the motor you need it for
 

· Registered
Joined
·
35 Posts
This sort of helps me. But I have the 2003 zx3 5sp 2.0 zetec. My gear selector on the Trans went out and I have no gears period. I was told there are 4 different transmission for my specific vehicle. Does anyone know what the difference is between them? My trans code is trrp0. Will a 2s4r7 fit and work? Can't find either the part or the Trans without paying over 1800.
 

· I
Joined
·
13,799 Posts
This sort of helps me. But I have the 2003 zx3 5sp 2.0 zetec. My gear selector on the Trans went out and I have no gears period. I was told there are 4 different transmission for my specific vehicle. Does anyone know what the difference is between them? My trans code is trrp0. Will a 2s4r7 fit and work? Can't find either the part or the Trans without paying over 1800.
Sounds like you broke the roll pin in the shift tower. Relatively easy fix.

 
1 - 10 of 10 Posts
Top