Ford Focus Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
401 Posts
Discussion Starter #1
I finally got around to installing this thing. I got everything hooked up but doi need to hook up the wire to the ignition switch. I am getting power to light the light so i know its wired good. Is this the missing piece to get a proper signal? If so is there a place i can tap off on the fuse panel? thanks
 

·
Registered
Joined
·
42 Posts
For power wire it to the wiper fuse and for lighting wire it to your parking light fuse (i did this so it would not stay lighted all the time). As for a signal to read the oil pressure, you may need a sending unit or maybe someone here knows which wire runs to the ecu with the proper signal you can tap into.
 

·
Registered
Joined
·
401 Posts
Discussion Starter #3
thanks. i already have it illuminated I just need to know if I have to wire up the sire that is suppoesed to go to the ignition switch or not. i have ll of the other wire hooked up. My question is will the wire to the ignition complet the circuit for the gauge to work?
 
1 - 5 of 5 Posts
Top