[CasperSE+]

How are they suppost to come on? Right now I have lows (outside beams) and the highs are the inside ones.

I read somewhere that for the highs you can have both on at the same time. Is this possible and/or ok to do? I know with the stock lights this is bad because it is two filiments in one bulb.

If its ok to do, what do I do differently to the wiring?

Thanks guys,

Brad

 

[Jared]

check this thread, where they talk about hooking up the HID's to do this. same headlights, but i think the wiring would be the same. although i could be horribly wrong.

http://www.focaljet.com/ubbthreads/showflat.php?Cat=&Board=UBB5&Number=93070&page=0&view=collapsed&sb=5&o=&fpart=1

 

[63330]

jumper wires 8&9 together in the harness that goes to your high beam yolk.
it is located on top of the steering column. if you need help in doing so, check out http://www.ofoc.ca/hid for more help.

 

[CasperSE+]

Thanks guys,

When we were installing them we looked for wires 8&9. But we looked at the headlight wiring, as those are numbered too.

Is it ok to have both on at the same time like that?

Im getting my hyperwhite H1's and H7's tonight cant, wait to see how they look.

Brad

 

[63330]

Casper, Yes it is safe to have both lows and highs on as long as the headlight bulbs is not dual filament.
I have it wired up like that on my Mach HID's

 

[Nacron]

Just don't keep them both on all the time...you'll cause accidents!

 

[bigman]

use a relay man. dont just jump them together.

 

[Ollie18]

use a relay man. dont just jump them together.

and why not?

 

[XmilllmontX]

my european headlights should be here end of this week... and i dont think they come with the bulbs for them.

so where would i get the high beam bulb(H7?), low beam bulb(H1?), and turn signal bulb(?)