Ford Focus Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
940 Posts
Discussion Starter #1 (Edited)
Well I just got done doing the first round of rev datalogs for my
FSWerks zetec turbo kit. Everything went smooth and my car runs
great. However, I notice the MAF voltage was not being datalogged.
It was staying at 0 the whole time. That is not right. Does anyone know
what might be the problem? I'm not getting any codes so it must be wired right.

EDIT: Nevermind. I got it figure out!
 

·
Registered
Joined
·
940 Posts
Discussion Starter #3
Apparently the upper case letter MAF VOLTS pid just doesn't work when I try to datalog with it. It just reads 0 the whole time
and there was not any other pids for dataloging the maf voltage. So I selected maf counts and saw that there was a drop down
bar where I could change it from displaying the maf counts to maf volts, like Raffi wants to see. So that is what I did and it works
fine now. This is while using Livelink Gen 2 by the way.
 
1 - 4 of 4 Posts
Top