Hey all, I made this quick video to show how to remove the whole air intake assembly – needed for many other jobs that require access to the rear of the engine bay. Check it out here and hope it helps:
2003 ZX5, 2.0L Zetec. ~235k miles
So the global pandemic has me working from home for the last few months, so I haven't been driving very much lately, although I have been making sure to drive it enough to get up to temp, circulate fluids, etc at least every week or so.
Yesterday I noticed...
I am having noise from my transmission, and want to get it rebuilt for the most part.
Looking at getting a bearing/seal kit, but I've run into an issue.
All of the kits I find ask if I have an 18.5mm or 20.5mm rear pinion bearing.
I have zero clue how to figure out what I have, and the...
Hey all, I had a leak coming from the camshaft position sensor – the O-ring failed on my car, and I was also getting a slightly random idle, so decided to replace it and clean up the oily mess. If you need to replace this sensor on your car, feel free to check out the video below – hope it helps…
So I swapped my motor, trans, ecu, PCM, and ENTIRE wire harness into a 2000 ford focus. My other one was 2007(had front end damage).
EVERY wire is hooked up correctly to my knowledge.
I checked every visible ground
Battery terminals are nice and clean
I removed terminals to reset the computer...