Ford Focus Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
175 Posts
Discussion Starter · #1 ·
I need to know what each wire does and where they go on the headlight switch. If you look at the back of the switch there is a hugh plug that plugs into the back of it, I need a diagram for that. Thanks.
 

·
Registered
Joined
·
438 Posts
For 2002 ford focus sedan

pin Circuit Circuit function
==========================================

1 15S-LG1 (GN/YE) voltage, ignition switch in start
or Run (not overload protected),
switched
91S-LG1 (BK/YE) Ground, switched
-----------------------------------------------------------
2 15-LG27 (GN/BK) Voltage, ignition switch in start
or run (not overload protected)
91-LG27 (BK/GN) Ground
-----------------------------------------------------------
3 15S-LG2 (GN/BU) Voltage, Ignition switch in Start
or Run (not overload protected),
switched
91S-LG2 (BK/BU) Ground switched
-----------------------------------------------------------
4 29-LG43 (OG/WH) Voltage supplied at all times
(overload protected) switched
-----------------------------------------------------------
5 91-LG43 (BK/WH) Ground
-----------------------------------------------------------
6 15-LE14 (GN/RD) Voltage, igntion switch in Start
or Run (not overload protected)
-----------------------------------------------------------
7 15S-LE12 (GN/YE) Voltage, ignition switch in Start
or Run (not overload protected)
switched
-----------------------------------------------------------
8 15S-LE12 (GN/RD) Voltage, ignition switch in Start
or Run (not overload protected)
switched
15S-LE19A (GN/BU) Voltage, ignition switch in Start
or Run (not overload protected)
-----------------------------------------------------------
9 15S-LE19 (GN/BU) Voltage, ignition switch in start
or Run (not overload protected),
switched
-----------------------------------------------------------
10 91-GE6 (BK/YE) Ground, Switched
-----------------------------------------------------------
MULTIFUNCTION SWITCH

pin 1 LH turn signal
pin 3 RH trun signal
pin 2 ground and Pin 5
Pin 4 is your buzzer
pin 7 is your high bean headlights and 9
Pin 8 6 voltage

please Double CHECK with multimeter
 

·
Registered
Joined
·
1,832 Posts
Ford Focus 2000-2001

Alarm and Keyless Entry Wiring Colors and Notes

Constant +12 Volts: RED IGNITION SWITCH HARNESS
Starter Kill: GRAY/BLACK IGNITION SWITCH HARNESS *
Ignition +12 Volts: GREEN/YELLOW IGNITION SWTICH HARNESS
Power Lock: BLACK/RED (-) DRIVER'S KICK IN DOOR BOOT ***
Power Unlock: BLACK/YELLOW (-) DRIVER'S KICK IN DOOR BOOT *** Trunk Release: BLACK/YELLOW (-) AT TRUNK RELEASE SWITCH

*** See Installation Note - Negative Pulse Door Lock Diagram.

Remote Starter Wiring Colors and Notes

Start: GRAY/BLACK IGNITION SWITCH HARNESS *
Ignition #1: GREEN/YELLOW IGNITION SWTICH HARNESS
Brake Light: GREEN/RED (+) AT SWITCH ABOVE PEDAL **
Tach Signal: BLACK/LT. GREEN AT COIL MODULE
Parking Lights: ORANGE/YELLOW (+) AT LIGHT SWITCH
* This Vehicle Is Equipped With Ford's Passive Anti-Theft System.
. ** This Wire Is Only Active When The Ignition Is On.

AUDIO NOTES:

radio constant 12v-- ORANGE/BLACK (thick)
radio ground--- BLK/YELLOW &BLK/GREEN
dimmer +12v---- ORANGE/BLACK(thin)
Lfront +white/blk -gray/blk
rfront +white/red - grey/red
Lrear + white/purple - grey/white
Rrear +white - grey

**also behind radio is the speed sense wire which is :: white/green
(handy for remote starts!**)

The keyless module is located behind the glove box to the right
There is where you can find a factory hood pin black/yellow

power windows are as follows:

LF windows up/dn---> yellow (drivers door motor), white
RF window up/dn-----> yellow/purple (driver switch or kick panel),
white/purple
LR window up/dn------> yellow/blue(driver switch or kick panel),
white/blue
RR window up/dn-------> yellow(driver switch or kick panel),white
 

·
Registered
Joined
·
2,538 Posts
Re: Getting a Ford CD

hit me up if you want it
 
1 - 6 of 6 Posts
Top