Ford Focus Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,095 Posts
Discussion Starter #1
Hey guys,

Right now I'm in the midst of installing cam gears on my car.
But I've run into a small problem, my cam alignment tool doesn't fit into the slots on the ends of the camshafts.
Whats up with this?

Is the metal bar I'm using too big?
By the looks of things, it looks like it be real hard to put any kind of bar into those slots.
Like my engine is sitting at TDC right now, and the slots are both horizontal, but my bar won't budge in there...

Any heads up out there?

Thanks
 

·
Registered
Joined
·
1,095 Posts
Discussion Starter #2
Oops, sorry, I'm an idiot, this can be deleted now!


I didn't notice that the notches on the ends of the cams were closer to one side than the other. So I just cranked the engine over again, and voila!
 
1 - 2 of 2 Posts
Top