Ford Focus Forum banner
1 - 9 of 9 Posts

funtruck

· Registered
Joined
·
109 Posts
Discussion starter · #1 ·
I bought these washers last year from a member here, (apologies, I forgot the screen name)

I'm finally getting around to my suspension refresh and could use some help in how to install these.

What order to these washers get stacked?

Image


Image
 
I had a delrin puck in there instead, so I don't know from experience how yours go in... but it looks like the upper set (in your pic) has a collar and the lower set is even across. If there is no recess on the bottom of the mount (after the shocks are in place), then I'd say the collar goes next to the top plate for the nut to tighten against... they both should go inside the mounting.
 
After a little searching through the suspension references thread, it looks like the 2" nylon washers are what I need. I'll pick some up tomorrow.

Image
A member named P-51 used to make these out of delrin for any who asked (haven't heard from him in a couple of years). Are you saying you can pick up nylon washers that will fit without modification... if so, please, post the location, because my old set was destroyed with my old car.
 
1 - 9 of 9 Posts