Ford Focus Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
I am sure this has been asked many times but my computer freaks out when I try to search. To all you guys out there that have bored the stock tb, what kind of "putty" did you use to give room to grind the rib? Thanks guys
 

·
Registered
Joined
·
714 Posts
Any 2 stage epoxy for use on plastic will do the job. I use the fast drying stuff, so you can have at it in short order. I have done 3 T/B's with no complaints. Bought it at Home Depot.
 

·
Registered
Joined
·
3,350 Posts
JB Weld; let it set up for 24 hours. Worked like a champ.
 

·
Driver > Car
Joined
·
23,988 Posts
2nd vote for jb weld. 4 bucks at autozone.
i didn't 'grind' mine down enough to warrant use of it however... just a tad.


edit: hell maybe i'll do that up today... i have the JB weld and in this snow it's not like im going anywhere...

[ 02-17-2003, 10:42 AM: Message edited by: demonfire ]
 
1 - 5 of 5 Posts
Top