Ford Focus Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
1,488 Posts
Discussion Starter #1
Sorry if this sounds stupid but dynos aren't cheap. Because my cams were installed with Piston at TDC and cam gears at zero and I assume everyone elses was too. Doesn't that make all of us with Cranes and similar mods the same? What could be different? In which case what did you guys set your gears at and what mods do you have with the Cranes? I just woke up and I'm absent minded so go gentle.
 

·
Registered
Joined
·
1,488 Posts
Discussion Starter #2
bump
 

·
Registered
Joined
·
65 Posts
I did extensive cam tuning with the Crane 2 cams. Straight up produced the best horsepower/torque. The cams are a matched set and designed to produce the best power at Crane recommended settings.
 

·
Registered
Joined
·
1,488 Posts
Discussion Starter #5
What are the crane recommended settings?
 

·
Registered
Joined
·
793 Posts
Originally posted by TRUenemy00:
</font><blockquote><font size="1" face="Verdana, Arial">quote:</font><hr /><font size="2" face="Verdana, Arial">Originally posted by doogie78:
What are the crane recommended settings?
<font size="2" face="Verdana, Arial">straight up (0,0) aren't you paying attention
</font><hr /></blockquote><font size="2" face="Verdana, Arial">
too funny !!
 

·
Registered
Joined
·
1,535 Posts
Originally posted by doogie78:
What are the crane recommended settings?
<font size="2" face="Verdana, Arial">0 intake
0 exhaust.

You can tune your gears to change the power band, but chances are you will lose some power.
 
1 - 8 of 8 Posts
Top