[3xz]

Where the heck is the place where I can plug the oil feed line?

Standing under the car looking forward, I see the starter laying horizontally, but I don't see any place to screw in the oil line (or just can't tell what I'm looking at).

HELP!! And please explain it like I'm a two year old!

Many many thanks before hand.

Also, I hate to sound like I don't know what I'm doing...but I don't know what I'm doing

Do I need to put a gasket between the exhaust manifold and the wastegate?

 

[1turbofocus]

Just to the rear of the starter (where it cannot be seen ) is an oil plug that goes in the oil galley it is about the width of 2 to 3 fingers from the rear of the starter if you go to far you will see the oil sending unit it is in between the sending unit and the starter and VERY hard to see from laying under it

Tom

 

[whiskeytangofoxtrot]

I hate to sound like I don't know what I'm doing...but I don't know what I'm doing Do I need to put a gasket between the exhaust manifold and the wastegate?

What are you doing, trying to ruin a perfectly good car?

 

[zx3focusguy]

I have no Idea why, but I have NO!!! oil pressure on that port on my motor. Trust me, I burned up my brand!! new turbonetics turbo in 500 miles

I ended up justt puting a "T" on my oil pressure sender. But everyone else is using that galley by the starter, I can't for the life of me figure why mine is like it is....

 

[1turbofocus]

Yes you need a gasket between the manifold and the waste gate

Tom

 

[3xz]

I figured that much, but it doesn't hurt to verify.

Thanks so much for your help!