Ford Focus Forum banner
1 - 1 of 9 Posts

· Registered
3,267 Posts
For the front of the car I use two points on the front cross member, if you look under the car towards the outer ends of the cross member you will see a raised area anout 1.5" wide and about 3" long. These pads make a perfect resting place for jack stands, I use these all the time and they work perfect. For the rear, I use the cross tube that runs between the lower control arm pivot points, the ends of the cross tubes have a shightly upward bend on either end but if you place your jack stands there at the end just before the upward bend it works great.
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.