Ford Focus Forum banner

1 - 20 of 29 Posts

·
Registered
Joined
·
390 Posts
Discussion Starter #1
i have 100 to spend on my engine this month...any ideas on what to get?? i have volant cai, fc pulleys, vibrant cat-back...ideas???
 

·
Registered
Joined
·
390 Posts
Discussion Starter #3
im lookin for good performance gains....or just in the butt dyno...im getting cams and gears next month...just need something to tie me over till then
 

·
Registered
Joined
·
526 Posts
If it's the offroad pipe... it's only six bolts! Very easy to swap the cat back in for any inspections. I just have a race header because there are no inspections in Michigan.
 

·
Registered
Joined
·
390 Posts
Discussion Starter #7
im afraid its going to make the car rediculously loud if i get that...will a flex pipe get me some gains??
 

·
Registered
Joined
·
144 Posts
Originally posted by KonaZXIII:
</font><blockquote><font size="1" face="Verdana, Arial">quote:</font><hr /><font size="2" face="Verdana, Arial"> Eny-ting you wan. Anything? Eny-ting.
<font size="2" face="Verdana, Arial">Sorry couldn't resist.
</font><hr /></blockquote><font size="2" face="Verdana, Arial">That was good


you should get the UDP works well on the Butt-Dyno
 

·
Registered
Joined
·
375 Posts
Originally posted by SilverZX3Bullet:
Where can you get a race pipe for $100?
<font size="2" face="Verdana, Arial">Look around a little, I found one that was only used for less than a month when the guy opted for a racing header. Still looked like new, and got it for $75 shipped.
 

·
Banned
Joined
·
17,312 Posts
He ALREADY HAS Pulleys.... Read his Post!!!
I'd go w/ the Flex-Pipe. It's in that range +/- $20.
BTW, the Focus doesn't HAVE a "Distributor"....

 

·
Registered
Joined
·
2,269 Posts
Originally posted by MichaelXi:
He ALREADY HAS Pulleys.... Read his Post!!!
I'd go w/ the Flex-Pipe. It's in that range +/- $20.
BTW, the Focus doesn't HAVE a "Distributor"....

<font size="2" face="Verdana, Arial">sorry im not big on this "reading" concept you speak of
 

·
Registered
Joined
·
733 Posts
managed to shatter a socket trying to loosen the bolts on the transmission mount to install those
bushings.. damn ....
 

·
Registered
Joined
·
19,264 Posts
The engine mount if you don't mind the more stiff feel that you'll need...

Plugs and wires maybe?

Flexpipe is always good for a few dollars more....

All of the above... available @ FocusSport.

Save another $100 and get a chip!!!!
 
1 - 20 of 29 Posts
Top