Ford Focus Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
I haven't had a chance to tune/dyno my car since I added most of the goodies, but I'm curious to what kind of power I should be putting to the wheels. my installed power mods are as follows:

JRSC w/ 2.6" Pulley
short ram intake
24lb injectors
FC 65mm TB
FC Adj Cam Gears
FC race header
FC flex pipe
borla exhaust

I also have a pro-flow 70mm MAF, but when installed my car couldn't hold an idle, so i took it off. I also have FC 3 piece UDP's. Should I install them with the JRSC?

thank ya.
 

·
Registered
Joined
·
2,838 Posts
no UDPs - sell them to me
 

·
Registered
Joined
·
734 Posts
i dunno what kinda power you should be making, but dont install those pulleys, it will mess with the speed of the supercharger.
 

·
Registered
Joined
·
471 Posts
This is just a guess. From other posts I think you are runnign about 10psi of boost using the 2.6 pully

If your Cam Gears adj to 0/0 you your base hp should be around lets say.. 125 wheel HP (this is a guess)

No i dont have my boost Excel sheet with me so i am going off some web calc that said 185.875 wheel hp. (that sounds way high to me.) I will check my boost sheet tonight.

but if you put the pulleys on you will bring your boost down to about 8psi.

as for the maf do you have it set up for your injectors or stock injectors

TragiC
 
1 - 4 of 4 Posts
Top