Ford Focus Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1,586 Posts
Discussion Starter #1
WOW i changed to the 3\"pulley and have about 7\" of belt leftover

it went from to tight to saggy butt.

is there a particular part number you guys have used when youve changed your JRSC pulley to a 3"?

If not ill just measure and see if i can find 1 about 7 1/4 - 7 1/2" shorter (how much slack does the tensioner pull)
 

·
Registered
Joined
·
1,586 Posts
Discussion Starter #2
Re: WOW i changed to the 3\"pulley and have about 7\" of belt leftover

Cool nevermind I tried 1 last route as I saw on another belt thread and it took up enough slack and not slipping.

going from the tension accross to the water pulley then back down to the crank
 
1 - 2 of 2 Posts
Top