seanmc will know - gary retorqued his after every session.

i want to say 32mm but i cant be sure. i could go take a wheel off my car, but work just called and might need me to drive (the hour) back to the office to fax like 4 papers somewhere. BAH

 

It is 30mm for the SVT. I assume all are the same.

 

32mm. That's what I just used half hour ago on SVT axle nuts.

 

This comes from Steve Powell at Tousley Ford:

Torque notes:

Front hub: 32 mm nut; torque spec is 316 NM (233 lb. ft.)

Rear hub: 30 mm nut; tightening is a 2-stage process:
- first tighten to 35 NM (25 lb. ft.)
- then, while rotating the hub in the opposite direction when tightening, tighten to 235 NM (173 lb. ft.)

 

On Gary's car, we always set the torque to big ****in impact turned all the way up. But yeah, it is a 32mm.